change config defaults for N8PC

Source/HBIOS/Config/N8PC_std.asm

@@ -52,7 +52,7 @@ BOOT_PRETTY	.SET	FALSE		; BOOT WITH PRETTY PLATFORM NAME
 AUTOCON		.SET	TRUE		; ENABLE CONSOLE TAKEOVER AT LOADER PROMPT
 ;
 CPUOSC		.SET	9216000	        ; CPU OSC FREQ IN MHZ
-INTMODE		.SET	2		; INTERRUPTS: 0=NONE, 1=MODE 1, 2=MODE 2, 3=MODE 3 (Z280)
+INTMODE		.SET	0		; INTERRUPTS: 0=NONE, 1=MODE 1, 2=MODE 2, 3=MODE 3 (Z280)
 ;
 RAMSIZE		.SET	512		; SIZE OF RAM IN KB (MUST MATCH YOUR HARDWARE!!!)
 ;

Source/HBIOS/cfg_N8PC.asm

@@ -68,7 +68,7 @@ STRICTPART	.SET	TRUE		; ENFORCE STRICT PARTITION TABLE VALIDATION
 CPUSPDCAP	.SET	SPD_FIXED	; CPU SPEED CHANGE CAPABILITY SPD_FIXED|SPD_HILO
 CPUSPDDEF	.SET	SPD_HIGH	; CPU SPEED DEFAULT SPD_UNSUP|SPD_HIGH|SPD_LOW
 CPUOSC		.SET	9216000		; CPU OSC FREQ IN MHZ
-INTMODE		.SET	2		; INTERRUPTS: 0=NONE, 1=MODE 1, 2=MODE 2, 3=MODE 3 (Z280)
+INTMODE		.SET	0		; INTERRUPTS: 0=NONE, 1=MODE 1, 2=MODE 2, 3=MODE 3 (Z280)
 ;
 RAMSIZE		.SET	512		; SIZE OF RAM IN KB (MUST MATCH YOUR HARDWARE!!!)
 ROMSIZE		.SET	512		; SIZE OF ROM IN KB (MUST MATCH YOUR HARDWARE!!!)
@@ -218,7 +218,7 @@ UART7BASE	.SET	$FF		; UART 7: REGISTERS BASE ADR
 UART7CFG	.SET	DEFSERCFG	; UART 7: SERIAL LINE CONFIG
 ;
 ASCIENABLE	.SET	TRUE		; ASCI: ENABLE Z180 ASCI SERIAL DRIVER (ASCI.ASM)
-ASCIINTS	.SET	TRUE		; ASCI: INCLUDE INTERRUPT SUPPORT UNDER IM1/2/3
+ASCIINTS	.SET	FALSE		; ASCI: INCLUDE INTERRUPT SUPPORT UNDER IM1/2/3
 ASCISWAP	.SET	FALSE		; ASCI: SWAP CHANNELS
 ASCIBOOT	.SET	0		; ASCI: REBOOT ON RCV CHAR (0=DISABLED)
 ASCI0CFG	.SET	DEFSERCFG	; ASCI 0: SERIAL LINE CONFIG