- Update TUNE.COM to mute sound card at end of playback when playing via HBIOS.
- Update SN76489 sound driver to use proper default port addresses.
- Modify Phil's CPU MHz speed rounding function to round up anytime speed in KHz is withing 500 KHz of next MHz increment.
- Reorganized most of the "common" files into special directories.
- Fixed bug affecting application boot related to ROM checksum test.
- Added support for LiNC sound card at default port address.
- The debug monitor will not display the current bank id in the prompt
- The debug monitor has a new command to set the current bank for the lower 32K
NOTE: Bank selection is not possible when running under interrupt mode 1. The command will be rejected with an error.
- The DSKY(ng) can display disk I/O activity as the system runs. This capability was implemented very erratically. This update overhauls the mechanism, makes it consistent, and implements it across all disk drivers.
- DSKYng now has same features as original DSKY including debug monitor
- Added support for MBS LEDs
- Elevated MBS to a platform instead of just a sub-config of SBC
- Allow any system timer to drive MKY interrupt, not just the TMS driver interrupt.
- Add a build check to ensure that when MKY is enabled, a system timer is also enabled.
Added BOOTCON config variable to allow setting the boot console device. This replaces FORCECON and removes the code that used to rearrange the PCINITTBL.
- Fix minor ACIA bug that only occurs if setting a non-standard baud rate.
- Enhance Z280 UART driver to use C/T for more baud rates and to use Z280 opcodes to speed up interrupt handler a bit.
- New Z280 bank selection routine that does not require gigantic table and is about as fast.
- Bump Z280 UART driver to 128 byte buffer.
- Truncate unused portion of Z280 IVT at end.