Prior improvement to IDE device detection broke detection of spinning hard disks. IDE registers cannot be used prior to device init completion (spin up). Not a problem for CF, but special steps required to ensure devices are fully initialized before register testing.
- Floppy devices are now configured per-device so that each floppy drive can be different (e.g., first floppy is 3.5" and second floppy is 5.25").
- Removed need to use termination signal on floppy sector I/O.
Addresses issue #318
If serial hardware flow control is enabled, but not working, then a system will appear dead because it won't send any data to the host computer. This change suppresses hardware flow control during boot just to ensure that boot messages can make it to the serial console. This will only be effective for serial interfaces that support dynamic management of HFC.
Edge case where the CPU speed detection routine would overflow in a fast emulator and return a speed of 0.000 MHz. Modified to fail back to the default CPU speed from the config file if an overflow occurs.
- Revamped CTC detection algorithm hoping to handle problem XRBR is having
- Fixed typo in dynamic CPU speed test that caused it to not be properly recorded/reported (credit XRBR)
- Allow use of DEL/RUBOUT keys as backspace in ROM Loader and Debug Monitor
- Set the default CPUOSC to 8MHz (default value in the project's
documentation), updated the User Guide
- Set the FDD controller to ZETA2 - regression introduced in bd664c3
cp/m fails to boot with the dma driver included but no dma hardware installed. This is because the default "dma_fail_flag" indicates that the dma is good to go. But in safe mode the dma initialization never takes place to find no dma and set this flag, so the memory driver hangs. This change is to make the default status of the flag the failed state so the memory driver will fallback to software in recovery mode.
